Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD)
RM2660E _52 Drivetrain _052808 CLUTCH _0255313 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install a new gasket to the master cylinder.


b.

Apply MP grease to the contact surface of the clevis and clutch pedal.


c.
C173260

Connect the clutch pedal to the clevis, and then install the master cylinder with the 2 nuts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


d.
C173249

Tighten the clutch pedal support bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 31434 2.CONNECT CLUTCH RESERVOIR TUBE

C173237

a.

Connect the clutch reservoir tube with a new clip.


Hide 31481 3.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C250845

a.

Using a union nut wrench, connect the tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 4.FILL RESERVOIR WITH BRAKE FLUID

Hide 6.CHECK FLUID LEVEL IN RESERVOIR

Hide 7.INSPECT FOR CLUTCH FLUID LEAK

Hide 31301 8.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY