Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD)
RM2660E _52 Drivetrain _052808 CLUTCH _0255313 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL PISTON AND SPRING

U164710E01
0.393,1.428 1.590,1.788 1.197,0.360 10 Lithium soap base glycol grease

a.

Apply lithium soap base glycol grease to the circumference of the cups and the contact surfaces of the piston and push rod.


b.

Install the spring and piston to the master cylinder.


Hide 31451 2.INSTALL CLUTCH MASTER CYLINDER PUSH ROD

C163273

a.

Fix the master cylinder in a vise.


b.

Install the push rod and plate to the master cylinder.


c.

Using snap ring pliers, install the snap ring.


d.

Install a new boot.


e.

Install the clevis to the push rod, and then temporarily install the nut.

HINT:

The lock nut will be tightened to a torque specification in the "Inspect and Adjust Clutch Pedal Sub-assembly" procedure.



Hide 3.INSTALL CLUTCH RESERVOIR GROMMET

C173218E01
1.632,1.251 2.924,1.636 1.292,0.385 10 1.5 to 3.5 mm (0.0591 to 0.138 in.)

a.

Install a new grommet and the inlet union.


b.

Using a pin punch and hammer, tap in the slotted spring pin as shown in the illustration.