Home › Drivetrain › CLUTCH › CLUTCH RELEASE CYLINDER
RM2660E _52 Drivetrain _052808 CLUTCH _0255314 CLUTCH RELEASE CYLINDER A

CLUTCH  CLUTCH RELEASE CYLINDER  INSTALLATION  


PROCEDURE

Hide 31470 1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

C271131

a.

Install the clutch release cylinder with the 3 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 31482D 2.INSTALL CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE

C271132

a.

Using a union nut wrench, connect the tube to the clutch accumulator and release cylinder.

Torque:
16 N*m (158 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



b.

Install the tube with the 2 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 31121 3.INSTALL NO. 1 CLUTCH HOUSING COVER

C172725

a.

Install the housing cover with the 3 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 4.FILL RESERVOIR WITH BRAKE FLUID

Hide 6.CHECK FLUID LEVEL IN RESERVOIR

Hide 7.INSPECT FOR CLUTCH FLUID LEAK