Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 1VD-FTV)
RM2660E _52 Drivetrain _052808 CLUTCH _0255318 CLUTCH UNIT(for 1VD-FTV) G

CLUTCH  CLUTCH UNIT(for 1VD-FTV)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C173318

a.

Using a vernier caliper, measure the rivet depth.

Minimum Rivet Depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.
C114037

Using a dial indicator, check the clutch disc runout.

Maximum Runout:

1.0 mm (0.0394 in.)


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C173319E02
0.656,0.438 1.073,0.583 0.417,0.146 10 false Width 0.677,1.042 1.083,1.229 0.406,0.188 10 false Depth

a.

Using a vernier caliper, inspect the depth and width of wear of the diaphragm spring.

Maximum Wear:
Depth Width
0.6 mm (0.0236 in.) 5.0 mm (0.197 in.)


If the wear is more than the maximum, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

C173320

a.

Using a dial indicator, inspect the flywheel runout.

Maximum Runout:

0.1 mm (0.00393 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

F050790

a.

Check that the clutch release bearing moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing (contact surfaces with the clutch cover) while applying force in the axial direction.


b.

Inspect the clutch release bearing for damage or wear.

Replace the release bearing assembly as necessary.


Hide 33311W 5.INSPECT INPUT SHAFT BEARING

Q002481

a.

Turn the bearing by hand while applying force in the direction of the rotation.

If the bearing is stuck or difficult to turn, replace the input shaft bearing.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.



Hide 33311W 6.REPLACE INPUT SHAFT BEARING

C173322E02
1.823,0.896 2.156,0.646 true 2.156,0.646 2.76,0.646 true 2.823,0.573 3.135,0.771 0.313,0.198 10 false SST

a.

Using SST, remove the bearing.

SST
09303-35011  


b.
C173321E02
1.521,1.083 2.083,0.708 true 2.073,0.708 2.438,0.708 false 2.531,0.625 2.906,0.833 0.375,0.208 10 false SST

Using SST and a hammer, install a new bearing.

SST
09304-12012  

HINT:

After installing the input shaft bearing to the engine side, make sure that it rotates smoothly.