Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2660E _52 Drivetrain _052809 H150F MANUAL TRANSMISSION / TRANSAXLE _0255323 INPUT SHAFT G

H150F MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33368 1.INSPECT NO. 2 SYNCHRONIZER RING

C171233

a.

Check for wear or damage.


b.

Coat the gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the gear cone. Check that the ring locks.


c.
C171234

Using a feeler gauge, measure the clearance between the synchronizer ring back and gear spline end.

Standard Clearance:

0.08 to 0.16 mm (0.0315 to 0.0629 in.)


Minimum Clearance:

0.08 mm (0.0315 in.)


If the clearance is less than the minimum, replace the synchronizer ring.