Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2660E _52 Drivetrain _052809 H150F MANUAL TRANSMISSION / TRANSAXLE _0255323 INPUT SHAFT A

H150F MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  REASSEMBLY  


PROCEDURE

Hide 33311A 1.INSTALL INPUT SHAFT FRONT BEARING

C171236E02
1.604,1.313 1.719,1.427 false 1.719,1.427 1.802,1.427 false 2.115,1.427 2.729,1.427 true 1.875,1.344 2.229,1.521 0.354,0.177 10 true SST

a.

Using SST and a press, install the input shaft front bearing to the input shaft.

SST
09316-20011  

HINT:

Make sure that the groove of the bearing faces the correct direction as shown in the illustration.



Hide 33311B 2.INSTALL FRONT BEARING SHAFT SNAP RING

C171237

a.

Select a new snap ring that will allow minimum clearance.

Standard Clearance:

0.1 mm (0.00393 in.) or less


Snap Ring Thickness:
Part No. Thickness Mark
90520-45003 2.50 to 2.55 mm
(0.0984 to 0.100 in.)
A
90520-45004 2.55 to 2.60 mm
(0.100 to 0.102 in.)
B
90520-45005 2.60 to 2.65 mm
(0.102 to 0.104 in.)
C
90520-45006 2.65 to 2.70 mm
(0.104 to 0.106 in.)
D
90520-45007 2.70 to 2.75 mm
(0.106 to 0.108 in.)
E
90520-45008 2.75 to 2.80 mm
(0.108 to 0.110 in.)
F



b.
C174274

Using a snap ring expander, install the snap ring to the input shaft.


Hide 33311D 3.INSTALL INPUT SHAFT BEARING

a.

Apply MP grease to the 12 roller bearings.


b.

Install the 12 roller bearings into the input shaft.