This DTC is output when communication is lost with the skid control ECU (master cylinder solenoid) or ECM.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| U0100 | 1.
Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) 2.
Communication is lost between ECM and 4 wheel drive control ECU 3.
5.12 seconds or more when transfer is switching between high and low 4.
1 trip detection logic |
CAN communication system |
| U0122 | 1.
Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) 2.
Communication is lost between skid control ECU and 4 wheel drive control ECU 3.
0.72 seconds or more when transfer is switching between high and low, or when center differential is switching between free and lock 4.
1 trip detection logic |
CAN communication system |
When the data in the ECM or skid control ECU (master cylinder solenoid) is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
Clear all DTCs, since DTCs are stored after the data in the ECM or skid control ECU (master cylinder solenoid) is overwritten.
Clear the DTCs (See page Drivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR).
Check if the same DTCs are output (See page Drivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to | |
|---|---|---|
| DTCs are output | for LHD with Central Gateway ECU | A |
| for LHD without Central Gateway ECU | B | |
| for RHD with Central Gateway ECU | C | |
| for RHD without Central Gateway ECU | D | |
| DTCs are not output | E | |
A
B
C
D
E
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)