Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › TRANSFER OIL
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255330 TRANSFER OIL A

JF2A TRANSFER / 4WD / AWD  TRANSFER OIL  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN TRANSFER OIL

a.
C173746

except 1GR-FE:

Remove the 2 bolts and transfer dynamic damper.


b.
C171487

Remove the 4 bolts and transfer heat insulator.


c.
C173748

Remove the 7 bolts and lower transfer case protector.


d.
C172047

Remove the filler plug and gasket.


e.
C172046

Remove the drain plug and gasket, and drain the transfer oil.


Hide 2.ADD TRANSFER OIL

a.
C172046

Install a new gasket onto the drain plug and then install the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.
C083746E21
2.063,0.26 3,0.458 0.938,0.198 10 false 0 to 5 mm

Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

NOTICE:
·

Add oil slowly.

·

Add oil a little at a time, waiting several minutes between each addition of oil.




c.

Wait approximately 5 minutes and check that the oil level has not changed.


d.
C172047

Install a new gasket onto the filler plug and then install the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


e.
C173748

Install the lower transfer case protector with the 7 bolts.

Torque:
14 N*m (139 kgf*cm, 10 ft.*lbf)


f.
C171487

Install the transfer heat insulator with the 4 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


g.
C173746

except 1GR-FE:

Install the transfer dynamic damper with the 2 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)