Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › TRANSFER OIL
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255330 TRANSFER OIL G

JF2A TRANSFER / 4WD / AWD  TRANSFER OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TRANSFER OIL

a.
C172047

Remove the filler plug and gasket.


b.
C083746E08
2.063,0.258 2.996,0.459 0.934,0.201 10 0 to 5 mm 0.103,2.015 0.481,2.148 0.378,0.134 3.016,1.968 3.414,2.136 0.398,0.168

Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

If the result is not as specified, add transfer oil.

Viscosity:

SAE 75W


Standard Capacity:

1.4 to 1.5 liters (1.5 to 1.6 US qts, 1.2 to 1.3 Imp. qts)


NOTICE:

Too much or too little oil will lead to transfer problems.



c.

When the oil level is too low, check for oil leaks.


d.
C172047

Install a new gasket onto the filler plug and then tighten the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 2.ADD TRANSFER OIL

a.
C172047

Remove the filler plug and gasket.


b.

Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

NOTICE:
·

Add oil slowly.

·

Add oil a little at a time, waiting several minutes between each addition of oil.




c.

Wait approximately 5 minutes and check that the oil level has not changed.


d.
C172047

Install a new gasket onto the filler plug and then tighten the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)