84010D
1.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Transmission)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (E) - 9 (CPU) | Mode switch being pushed and held
(CTR DIFF) |
Below 1 Ω |
| Mode switch not pushed
(CTR DIFF) |
10 kΩ or higher |
| *a | Component without harness connected
(Integration Control and Panel Assembly) |
If the result is not as specified, replace the integration control and panel assembly.
84725
2.INSPECT CENTER DIFFERENTIAL LOCK SWITCH (for Manual Transmission)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (E) - 9 (CPU) | Center differential lock switch being pushed and held | Below 1 Ω |
| Center differential lock switch not pushed | 10 kΩ or higher |
| *a | Component without harness connected
(Center Differential Lock Switch) |
If the result is not as specified, replace the center differential lock switch.