Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM2660E _52 Drivetrain _052811 DRIVE SHAFT / PROPELLER SHAFT _0255346 FRONT PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 37140 1.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

a.
C172297

Using a dial indicator, measure the propeller shaft runout.

Maximum runout:

0.8 mm (0.031 in.)


If the shaft runout is more than the maximum, replace the shaft.


Hide 2.INSPECT SPIDER BEARING

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


a.
C172298

Check the spider bearings for wear or damage.


b.

Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0 mm (0 in.)


If the axial play is more than the maximum, replace the spider bearing.


Hide 3.FILL PROPELLER SHAFT WITH GREASE

a.

Fill each of the grease fitting holes of the propeller shaft with MP grease.

C358769E01
1.167,0.719 1.917,0.917 0.75,0.198 10 false Sliding Area 5.021,1.292 5.875,1.5 0.854,0.208 10 false Vehicle Front

NOTICE:

Stop filling the grease fitting hole on the middle portion of the propeller shaft once the sliding portion starts extending.



b.

Drive the vehicle.

NOTICE:

Check the safety of the surrounding areas.


HINT:

Move the vehicle forward and in reverse 5 times and strongly apply the brake.



c.

Lift up the vehicle and wipe off any excess grease as a result of driving.