Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM2660E _52 Drivetrain _052811 DRIVE SHAFT / PROPELLER SHAFT _0255346 FRONT PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


PROCEDURE

Hide 1.CLEAN PROPELLER SHAFT GREASE

a.
C237251E04
1.198,0.375 1.396,0.375 1.396,0.375 1.75,0.958 false 1.51,1.083 1.271,0.385 false 0.479,0.292 1.448,0.5 0.969,0.208 10 false Matchmark

Place matchmarks on the propeller shaft and sleeve yoke.


b.

Disconnect the sleeve yoke from the propeller shaft.


c.

Clean off any grease on the spline.


Hide 04371G 2.REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER ASSEMBLY

a.
C172299E01
1.017,0.389 1.506,0.389 1.506,0.389 1.9,0.806 false 1.654,0.954 1.151,0.392 false 0.124,0.291 0.981,0.492 0.857,0.202 10 Matchmark

Place matchmarks on the flange yoke and sleeve yoke or propeller shaft.


b.
C172300

Using a brass bar and hammer, slightly tap in the spider bearing outer races.


c.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.


d.
C172301E03
1.072,0.871 1.506,1.073 0.434,0.202 10 SST 0.829,1.039 0.963,0.956 0.963,0.956 1.04,0.955 false 3.018,0.741 3.167,0.890 0.149,0.149 10 A 2.543,1.034 2.796,0.835 2.796,0.835 2.995,0.831 false

Using SST, push out the bearing from the flange.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



e.
C115614

Clamp the bearing outer race in a vise and tap off the flange with a hammer.

HINT:

Remove the bearing on the opposite side using the same procedure.



f.

Remove the flange yoke from the sleeve yoke (or propeller shaft).


g.
C115615E02
1.497,0.654 1.889,0.887 0.392,0.232 10 SST 2.202,0.884 2.017,0.748 2.017,0.748 1.868,0.748 false

Install the 2 removed bearing outer races to the spider.


h.

Using SST, push out the bearing from the yoke.

SST
09332-25010  


i.

Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

HINT:

Remove the bearing on the opposite side using the same procedure.