Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM2660E _52 Drivetrain _052811 DRIVE SHAFT / PROPELLER SHAFT _0255347 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


PROCEDURE

Hide 1.CLEAN PROPELLER SHAFT GREASE

a.
C237250E03
1.771,1 1.594,0.406 true 2.031,0.823 1.844,0.406 1.844,0.406 1.292,0.406 true 0.542,0.344 1.792,0.677 1.25,0.333 10 false Matchmark

Place matchmarks on the propeller shaft and sleeve yoke.


b.

Disconnect the sleeve yoke from the propeller shaft.


c.

Clean off any grease on the spline.


Hide 04371H 2.REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER ASSEMBLY

a.
U156176E01
1.315,0.482 1.607,1.015 false 1.881,0.775 1.68,0.475 1.68,0.475 1.218,0.482 false 0.264,0.394 1.068,0.541 0.804,0.147 10 Matchmark

Place matchmarks on the flange yoke and sleeve yoke or propeller shaft.


b.
C175287

Using a brass bar and hammer, slightly tap in the spider bearing outer races.


c.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.


d.
C175288E01
0.835,1.096 0.951,0.96 0.951,0.96 1.083,0.961 false 1.108,0.846 1.426,1.016 0.318,0.170 10 SST 2.544,1.033 2.853,0.9 2.853,0.9 2.987,0.898 false 3.012,0.783 3.133,0.953 0.121,0.170 10 A

Using SST, push out the bearing from the flange.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



e.
C115614

Clamp the bearing outer race in a vise and tap off the flange with a hammer.

HINT:

Remove the bearing on the opposite side using the same procedure.



f.

Remove the flange yoke from the sleeve yoke (or propeller shaft).


g.

Install the 2 removed bearing outer races to the spider.


h.
C175293E01
1.528,0.947 1.857,1.117 0.329,0.170 10 SST 1.887,1.056 1.998,1.054 1.998,1.054 2.183,1.168 false

Using SST, push out the bearing from the yoke.

SST
09332-25010  


i.

Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

HINT:

Remove the bearing on the opposite side using the same procedure.