41110
1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Install a new gasket.
Install the differential carrier with the 10 washers and 10 nuts.
Connect the differential lock shift actuator and No. 4 transfer indicator switch clamps.
Connect the breather hose.
37110
2.CONNECT PROPELLER SHAFT ASSEMBLY
Align the matchmarks on the yoke and differential flange.
| *1 | Bolt |
| *2 | Washer |
| *3 | Matchmark |
Connect the propeller shaft with the 4 bolts, 4 washers and 4 nuts.
41467A
3.INSTALL REAR DIFFERENTIAL LOCK ACTUATOR PROTECTOR
Install the protector with the 2 nuts.
41170
4.INSTALL DIFFERENTIAL PROTECTOR ASSEMBLY
Attach the protector with the bolt and nut.
Connect the 2 connector clamps and wire harness clamp.
Make sure the wire harness of the No. 4 transfer indicator switch fits inside the protector.
5.INSTALL REAR AXLE SHAFT
Install the rear axle shaft (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT>INSTALLATION).
6.ADD DIFFERENTIAL OIL