1.LOCK REAR DIFFERENTIAL
Turn the engine switch on (IG).
Push on the 4WD switch.
Turn the differential lock control switch to the RR position and lock the rear differential.
Rotate the rear wheels to check that they are in the differential lock condition.
2.DRAIN DIFFERENTIAL OIL
3.REMOVE REAR AXLE SHAFT
Remove the axle shaft (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT>REMOVAL).
41170
4.REMOVE DIFFERENTIAL PROTECTOR ASSEMBLY
Detach the 2 connector clamps and wire harness clamp.
Remove the bolt, nut and protector.
41467A
5.REMOVE REAR DIFFERENTIAL LOCK ACTUATOR PROTECTOR
Remove the 2 nuts and protector.
6.DISCONNECT REAR PROPELLER SHAFT ASSEMBLY
Place matchmarks on the rear propeller shaft and companion flange.
Remove the 4 nuts, 4 washers and 4 bolts, and disconnect the propeller shaft from the differential side.
Support the propeller shaft securely.
7.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
Disconnect the lock differential lock shift actuator and No. 4 transfer indicator switch connectors.
Disconnect the breather hose.
Remove the 10 nuts, 10 washers and differential carrier assembly.
Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.
Remove the gasket.