Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › 2014.08–2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION D

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  DIAGNOSIS SYSTEM  


DIAGNOSIS SYSTEM


a.

If a malfunction is detected in the active height control suspension, the master warning light illuminates, and "Check 4-WHEEL AHC System" is displayed on the multi-information display.


b.

Test mode

i.

By switching from normal mode into test mode, the front acceleration sensor, rear acceleration sensor and suspension control switch can be inspected (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>TEST MODE PROCEDURE).




INITIAL CHECK


a.

The initial check operates for approximately 3 seconds after the engine switch is turned on (IG). Therefore, the vehicle height information does not display on the height control indicator in the multi-information display. After the initial check is finished, the vehicle height information is displayed.