Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › 2014.08–2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION C

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  U0100  Lost Communication with ECM / PCM "A"  U0101  Lost Communication with TCM  U0114  Lost Communication with 4WD Control ECU  U0122  Lost Communication with Vehicle Dynamics Control Module  U0124  Lost Communication with Lateral Acceleration Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0130  Lost Communication with VGRS  U0140  Lost Communication with Main Body ECU  


DESCRIPTION

The suspension control ECU receives signals from the ECM, four wheel drive control ECU, skid control ECU, yaw rate sensor, steering sensor, steering control ECU and main body ECU via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC Code Detection Condition Trouble Area
U0100 While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more.
·

CAN communication system

·

ECM

·

Suspension control ECU


U0101 While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more.
·

CAN communication system

·

ECM

·

Suspension control ECU


U0114 While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and four wheel drive control ECU stops for 3 seconds or more.
·

CAN communication system

·

Four wheel drive control ECU

·

Suspension control ECU


U0122 CAN communication between the suspension control ECU and skid control ECU stops for 3 seconds or more.
·

CAN communication system

·

Skid control ECU

·

Suspension control ECU


U0124 CAN communication between the suspension control ECU and yaw rate sensor stops for 3 seconds or more.
·

CAN communication system

·

Yaw rate sensor

·

Suspension control ECU


U0126 CAN communication between the suspension control ECU and steering sensor stops for 3 seconds or more.
·

CAN communication system

·

Steering sensor

·

Suspension control ECU


U0130 5 seconds after the engine switch is turned on (IG), CAN communication between the suspension control ECU and steering control ECU stops for 3 seconds or more.
·

CAN communication system

·

Steering control ECU

·

Suspension control ECU


U0140 CAN communication between the suspension control ECU and main body ECU stops for 5 seconds or more.
·

CAN communication system

·

Main body ECU

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, inspect the connectors of related circuits.

·

If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).



PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK DTC
2.CHECK DTC
a.

Perform a road test.


b.

Check for DTCs.

OK:

DTC is not output.


Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

C

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)