Home › Suspension › SUSPENSION CONTROL › SUSPENSION CONTROL SYSTEM
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255368 SUSPENSION CONTROL SYSTEM G

SUSPENSION CONTROL  SUSPENSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK FLUID LEVEL IN RESERVOIR

a.
C176461

With the vehicle empty, after setting the vehicle height to NORMAL from LO, check the indicator to make sure the vehicle height is NORMAL and check that the fluid level in the reservoir tank is within the specified range (MAX, MIN).

HINT:

After changing the vehicle height from LO to NORMAL, do not stop the engine for 25 seconds because the pressure control for the main accumulator is operating. After that, check the fluid level.



Hide 2.INSPECT FOR SUSPENSION FLUID LEAK

a.

Check that the union nuts shown in the illustration are tightened to the specified torque.

Torque:
without union nut wrench : 15 N*m (155 kgf*cm, 11 ft.*lbf)
with union nut wrench : 14 N*m (143 kgf*cm, 10 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

·

The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.




b.

Check for fluid leakage from the parts and connections.

C176381E01
3.831,0.89 6.244,1.039 2.413,0.149 10 Active Height Control Pump and Motor 1.077,6.173 3.212,6.324 2.135,0.151 10 Center Unit (Vehicle Interior Side): 3.694,6.185 5.878,6.336 2.184,0.151 10 Center Unit (Vehicle Exterior Side): 6.276,4.609 6.959,4.758 0.684,0.149 10 Union Nut 6.234,4.676 5.99,4.676 false 5.99,4.676 5.78,5.348 false 0.222,1.959 0.884,2.108 0.662,0.149 10 Union Nut 0.895,2.031 1.616,2.019 false 1.624,2.178 0.895,2.031 false

HINT:

For union nuts and union bolts not shown in the illustration, refer to the installation procedures for each title.