Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR (for Front Side)
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255372 HEIGHT CONTROL SENSOR(for Front Side) G

SUSPENSION CONTROL  HEIGHT CONTROL SENSOR(for Front Side)  INSPECTION  


PROCEDURE

Hide 89406 1.INSPECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

C358241E01
4.844,1.396 4.948,1.396 4.948,1.396 5.073,1.792 true 5.25,1.771 5.375,0.781 5.375,0.781 5.563,0.781 true 5.438,1.875 5.438,2.552 5.438,2.552 5.552,2.552 true 0.979,0.177 1.583,0.406 0.604,0.229 10 false Min. LO 0.729,1.208 1.333,1.438 0.604,0.229 10 false Normal 1.177,2.156 1.781,2.385 0.604,0.229 10 false Max. HI 0.25,2.094 0.854,2.323 0.604,0.229 10 false *1: for RH 0.24,2.406 0.844,2.635 0.604,0.229 10 false *2: for LH 1.75,1.531 2.031,1.771 0.281,0.24 10 false 45° 1.76,0.76 2.083,0.99 0.323,0.229 10 false 45° 4.354,1.323 4.958,1.552 0.604,0.229 10 false 3 (SHB) 5.604,2.458 6.208,2.688 0.604,0.229 10 false 1 (SHG) 5.583,0.688 7,0.917 1.417,0.229 10 false 2 (SHFR*1, SHFL*2) 3.917,0.115 6.417,0.604 2.5,0.49 10 false Component without harness connected: (Front Height Control Sensor)

NOTICE:

Do not drop the height control sensor. If it is dropped, replace it with a new one.


a.

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHFR*1, SHFL*2) and terminal 1 (SHG).

HINT:

*1: for RH

*2: for LH


i.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
for RH
Tester Connection Condition Specified Condition
2 (SHFR) - 1 (SHG) Max. HI Approx. 4.1 V
Normal Approx. 2.25 V
Min. LO Approx. 0.45 V

for LH
Tester Connection Condition Specified Condition
2 (SHFL) - 1 (SHG) Max. HI Approx. 4.1 V
Normal Approx. 2.25 V
Min. LO Approx. 0.45 V


NOTICE:

Do not apply a voltage of higher than 6 V.


If the result is not as specified, replace the front height control sensor.