1.ADJUST REAR HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
Make adjustments from the link that deviates the most from the specified vehicle height value.
When the front and rear are at the same level, make adjustments from the front first.
If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.
Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.
When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).
Tighten the nut of the height control sensor link.
2.PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
Perform the vehicle height offset calibration (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
3.PERFORM ZERO POINT CALIBRATION OF G SENSOR
Perform the zero point calibration of G sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
4.ADJUST FRONT WHEEL ALIGNMENT
Adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).
5.ADJUST HEADLIGHT ASSEMBLY
for Standard:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Halogen Headlight)>ADJUSTMENT).
for HID Headlight:
Adjust the headlight (See page LIGHT (EXT) > HEADLIGHT ASSEMBLY (for HID Headlight) > ADJUSTMENT).