1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR WHEEL
89408D
3.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Disconnect the connector and 2 clamps.
Remove the 2 bolts, nut and sensor.
89407B
4.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
Disconnect the connector and 2 clamps.
Remove the 2 bolts, nut and sensor.