Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255380 FRONT ACCELERATION SENSOR G

SUSPENSION CONTROL  FRONT ACCELERATION SENSOR  INSPECTION  


PROCEDURE

Hide 89191A 1.INSPECT ACCELERATION SENSOR

C177935E07
2.854,1.5 3.115,0.885 3.115,0.885 3.167,0.885 true 2.615,1.604 2.469,2.25 2.469,2.25 2.469,2.375 true 1.469,1.885 1.604,1.885 1.604,1.885 2.427,1.604 true 5.875,0.281 6.406,0.479 0.531,0.198 10 false Upside 4.74,2.281 5.5,2.469 0.76,0.188 10 false Downside 1.135,1.813 1.448,2.01 0.313,0.198 10 false SGB 2.333,2.417 2.677,2.615 0.344,0.198 10 false SGG 3.208,0.813 4.479,0.99 1.271,0.177 10 false SGFR*1, SGFL*2 0.115,2.083 0.771,2.25 0.656,0.167 10 false *1: for RH 0.115,2.385 0.75,2.615 0.635,0.229 10 false *2: for LH 0.135,0.073 2.646,0.479 2.51,0.406 10 false Component without harness connected: (Acceleration Sensor)

NOTICE:

Do not drop the acceleration sensor. If it is dropped, replace it with a new one.


a.

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the battery to terminal 3 (SGB) of the acceleration sensor and the negative (-) end of the battery to terminal 2 (SGG). Then measure the voltage between terminal 1 (SGFR*1, SGFL*2) and terminal 2 (SGG).

HINT:

*1: for RH

*2: for LH



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
for RH
Tester Connection Condition Specified Condition
1 (SGFR) - 2 (SGG) Sensor is stationary Approx. 2.0 to 2.5 V
Sensor is tilted Change between approx. 0.9 to 2.3 V

for LH
Tester Connection Condition Specified Condition
1 (SGFL) - 2 (SGG) Sensor is stationary Approx. 2.0 to 2.5 V
Sensor is tilted Change between approx. 0.9 to 2.3 V


NOTICE:

Do not apply a voltage of higher than 6 V.


HINT:

The voltage may differ according to the amount that the sensor is tilted.


If the result is not as specified, replace the acceleration sensor.