Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(w/ KDSS)
RM2660E _53 Suspension _052815 FRONT SUSPENSION _0255386 FRONT STABILIZER BAR(w/ KDSS) G

FRONT SUSPENSION  FRONT STABILIZER BAR(w/ KDSS)  INSPECTION  


PROCEDURE

Hide 48820B 1.INSPECT FRONT STABILIZER LINK ASSEMBLY RH

C124387

a.

Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.


b.

Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)


If the value is not within the specified range, replace the front stabilizer link with a new one.



c.

Check the dust boot for cracks or grease leakage.