Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2014.08–2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.

Disconnect the tire pressure warning ECU and receiver L60 connector and measure the voltage and resistance on the wire harness side.

U165431E01
0.423,0.111 0.656,0.322 0.232,0.211 10 *a 1.981,0.936 2.339,1.085 0.357,0.149 10 L60

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L60-1 (IG1) - L60-4 (GN1) B - G IG power source Engine switch on (IG) 10 to 16 V
L60-4 (GN1) - Body ground G - Body ground Ground Always Below 1 Ω


b.

Connect the tire pressure warning ECU and receiver L60 connector.


c.

Measure the voltage according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U165430E01
0.365,0.134 0.661,0.344 0.296,0.210 10 *a 1.624,0.869 1.986,1.032 0.363,0.163 10 L60

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L60-2 (CS1) - L60-4 (GN1) R - G Tire pressure warning reset switch
·

Engine switch on (IG)

·

Tire pressure warning reset switch ON


Below 2.4 V
·

Engine switch on (IG)

·

Tire pressure warning reset switch OFF


8 to 15 V