Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255406 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 42603 3.REMOVE FRONT WHEEL

Hide 89516 4.REMOVE FRONT SKID CONTROL SENSOR WIRE LH

a.
C177132

Disconnect the connector from the front speed sensor.


b.

Remove the bolt and harness clamp.


c.

Remove the nut and harness clamp.


d.
C170882

Remove the 2 bolts and 2 harness clamps.


e.
U156114

w/o AHC:

Disconnect the connector and then remove the bolt, harness clamp and sensor wire.


f.
U157313

w/ AHC:

Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.


Hide 89543 5.REMOVE FRONT SPEED SENSOR LH

a.
C271342

Remove the bolt and speed sensor from the knuckle.

NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.



Hide 89516 6.REMOVE FRONT SKID CONTROL SENSOR WIRE RH

a.
C177133

Disconnect the connector from the front speed sensor.


b.

Remove the bolt and harness clamp.


c.

Remove the nut and harness clamp.


d.

w/o AHC:

i.
C172203

Disconnect the connector.


ii.

Detach the connector from the skid control sensor clamp.


iii.

Remove the bolt and skid control sensor clamp.


iv.

Remove the 2 bolts, 2 harness clamps and sensor wire.



e.

w/ AHC:

i.
C170887

Disconnect the connector.


ii.

Detach the connector from the skid control sensor clamp.


iii.

Remove the bolt and skid control sensor clamp.


iv.

Remove the 2 bolts and 2 harness clamps.


v.
C170888

Disconnect the connector and then remove the bolt, harness clamp and sensor wire.



Hide 89542 7.REMOVE FRONT SPEED SENSOR RH

a.
C271343

Remove the bolt and speed sensor from the knuckle.

NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.