Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255407 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 42603 3.REMOVE REAR WHEEL

Hide 89516B 4.REMOVE SKID CONTROL SENSOR WIRE

a.
C170899

Disconnect the speed sensor LH connector.


b.

Detach the 2 clamps and remove the bolt and sensor clamp.

C170896


c.

Detach the 5 clamps.

C170897


d.

Detach the 3 clamps.

C170898


e.
C170895

Disconnect the speed sensor RH connector.


f.
U156118

Remove the bolt.


g.
U156119

Disconnect the connector, and remove the bolt and skid control sensor wire.


Hide 89546 5.REMOVE REAR SPEED SENSOR LH

a.
C170903

Remove the nut and speed sensor.

NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.



Hide 89545 6.REMOVE REAR SPEED SENSOR RH

a.
C170902

Remove the nut and speed sensor.

NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.