Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255412 RELAY G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK BRK LP RELAY

a.

Remove the BRK LP relay from the engine room relay block.


b.
A087121E43
2.333,0.625 2.333,0.313 false 2.479,1.135 2.948,1.135 false 2.479,1.635 2.948,1.635 false 2.031,0.625 1.854,0.313 false 2.604,0.625 2.781,0.313 false 0.313,1.417 0.51,1.625 0.198,0.208 10 false 1 1.75,0.125 1.948,0.333 0.198,0.208 10 false 1 1.313,1.417 1.51,1.625 0.198,0.208 10 false 2 2.76,0.104 2.958,0.313 0.198,0.208 10 false 2 0.313,0.865 0.51,1.073 0.198,0.208 10 false 3 3.01,1.542 3.208,1.75 0.198,0.208 10 false 3 0.938,0.385 1.135,0.594 0.198,0.208 10 false 4 2.292,0.104 2.49,0.313 0.198,0.208 10 false 4 1.313,0.865 1.51,1.073 0.198,0.208 10 false 5 3.01,1.042 3.208,1.25 0.198,0.208 10 false 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery positive voltage applied to terminal 1 and battery negative voltage to terminal 2 10 kΩ or higher
Battery positive voltage not applied to terminal 1 and battery negative voltage applied to terminal 2 Below 1 Ω
3 - 5 Battery positive voltage applied to terminal 1 and battery negative voltage to terminal 2 Below 1 Ω
Battery positive voltage not applied to terminal 1 and battery negative voltage applied to terminal 2 10 kΩ or higher


If the result is not as specified, replace the relay.


c.

Install the BRK LP relay.