The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
The yaw rate and acceleration sensor (airbag sensor assembly) has a built-in acceleration sensor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1442 | An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. | Yaw rate and acceleration sensor (Airbag sensor assembly) |
| C1443 | An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. | Yaw rate and acceleration sensor (Airbag sensor assembly) |
After replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1442 or C1443 is output | A |
| CAN communication system DTC is output | B |
| DTC is not output | C |
For the CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING), refer to the following:
for LHD (with Central Gateway ECU): See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD (without Central Gateway ECU): See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD (with Central Gateway ECU): See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD (without Central Gateway ECU): See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)