DTC C1282 is stored only in test mode.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1282 | Stored during test mode. | ·
Harness or connector ·
Transfer system |
Switch the vehicle to test mode, perform the center differential lock signal check, and then check that the Test Mode (Signal Check) DTC C1282 is cleared (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).
| Result | Proceed to |
|---|---|
| Test Mode DTC C1282 is cleared | A |
| Test Mode DTC C1282 is not cleared | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Disconnect the A24 skid control ECU (master cylinder solenoid) connector.
Disconnect the A27 4 wheel drive control ECU connector.
Disconnect the C37 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-27 (EXI) - A27-14 (P1) | Always | Below 1 Ω |
| A24-27 (EXI) - C37-3 (CDL) | Always | Below 1 Ω |
| A24-27 (EXI) - Body ground | Always | 10 kΩ or higher |
OK
NG