89299F
1.CHECK SUSPENSION CONTROL SWITCH (CRAWL SWITCH)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 18 (SW02) - 16 (E) | Speed selector switch: Medium | 10 kΩ or higher |
| Speed selector switch: Medium-high | ||
| Speed selector switch: High | ||
| Speed selector switch: Low | Below 1 Ω | |
| Speed selector switch: Medium-low | ||
| 19 (ECU2) - 16 (E) | Speed selector switch: Medium-low | 10 kΩ or higher |
| Speed selector switch: Medium | ||
| Speed selector switch: Medium-high | ||
| Speed selector switch: Low | Below 1 Ω | |
| Speed selector switch: High | ||
| 13 (SW04) - 16 (E) | Speed selector switch: Low | 10 kΩ or higher |
| Speed selector switch: Medium-low | ||
| Speed selector switch: Medium | ||
| Speed selector switch: Medium-high | Below 1 Ω | |
| Speed selector switch: High | ||
| 14 (HSW) - 16 (E) | ON/OFF switch: Pressed | Below 1 Ω |
| ON/OFF switch: Not pressed | 10 kΩ or higher | |
| 2 (ECU) - 16 (E) | Turn assist function switch: Pressed | Below 1 Ω |
| Turn assist function switch: Not pressed | 10 kΩ or higher |
| *1 | CRAWL ON/OFF Switch |
| *2 | Turn Assist Function Switch |
| *3 | CRAWL Speed Selector Switch |
| *a | Component without harness connected:
(CRAWL Switch) |
If the result is not as specified, replace the suspension control switch (CRAWL switch).