Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM2660E _54 Brake _052821 BRAKE (FRONT) _0255429 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash brake fluid off immediately if it is spilled on any painted surface.


Hide 3.REMOVE FRONT DISC BRAKE PAD

a.
C165344

Remove the pin hold clip.

NOTICE:

The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign particles cleaned off.



b.

Remove the 2 hole pins.


c.
C170925

Remove the front disc brake anti-rattle spring.

NOTICE:

The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign particles cleaned off.



d.
C170926

Remove the 2 pads from the disc brake caliper.


e.

Remove the No. 1 anti-squeal shims from each pad.


Hide 47313A 4.DISCONNECT FRONT FLEXIBLE HOSE

a.
C165345

Remove the union bolt and gasket, and then disconnect the flexible hose.


Hide 47750 5.REMOVE DISC BRAKE CALIPER ASSEMBLY LH

a.
C165346

Remove the 2 bolts and disc brake caliper from the knuckle.


Hide 43512 6.REMOVE FRONT DISC

a.
C170927E01
2.516,0.061 3.247,0.235 0.731,0.174 10 Matchmark 1.736,1.101 1.736,0.143 1.736,0.143 2.476,0.143 false 1.736,1.184 2.02,1.184 2.02,1.184 2.02,0.143 false

Put matchmarks on the front disc and axle hub if planning to reuse the disc.


b.

Remove the front disc.