Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM2660E _54 Brake _052821 BRAKE (FRONT) _0255429 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 47731A 1.REMOVE FRONT DISC BRAKE PISTON SET RING

a.
C165347

Using a screwdriver, remove the 4 set rings from the 4 cylinder boots.

HINT:

Tape the screwdriver tip before use.



Hide 2.REMOVE CYLINDER BOOT

a.

Using a screwdriver, remove the 4 cylinder boots from the disc brake caliper.

HINT:

Tape the screwdriver tip before use.



Hide 47731 3.REMOVE FRONT DISC BRAKE PISTON

a.
C172156E01
2.229,0.094 3.138,0.248 0.909,0.155 10 Wooden Plate 1.574,0.407 1.574,0.169 1.574,0.169 2.164,0.169 false

Install one side of the disc brake pad.


b.

Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.


c.

Using an air gun, gradually apply air and remove the 2 disc brake pistons from the cylinder.

CAUTION:

Do not place your fingers in front of the pistons when using air gun.



d.

Remove the brake pad and wooden plate.


e.

Temporarily install the 2 disc brake pistons that were removed. Then install the disc brake pad to the side in which the 2 disc brake pistons are temporarily installed.


f.

Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.


g.

Using an air gun, gradually apply air and remove the 2 disc brake pistons from the other side of the cylinder.

CAUTION:

Do not place your fingers in front of the pistons when using air gun.



Hide 4.REMOVE PISTON SEAL

a.
C165348

Using a screwdriver, remove the 4 piston seals from the disc brake caliper.

NOTICE:

Do not damage the inner cylinder and cylinder groove.


HINT:

Tape the screwdriver tip before use.



Hide 31478B 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 47547B 6.REMOVE FRONT DISC BRAKE BLEEDER PLUG