Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1VD-FTV) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255446 VANE PUMP(for 1VD-FTV) G

POWER ASSIST SYSTEMS  VANE PUMP(for 1VD-FTV)  INSPECTION  


PROCEDURE

Hide 1.CHECK OIL CLEARANCE BETWEEN VANE PUMP SHAFT AND VANE PUMP REAR HOUSING BUSHING

a.
C161394E01
2.622,0.14 2.923,0.379 0.302,0.239 10 [b] 1.153,1.646 1.455,1.885 0.302,0.239 10 [a] 2.566,0.244 2.325,0.244 2.325,0.244 2.093,1.107 false

Using a micrometer, measure the outer diameter [a] of the shaft.


b.

Using a vernier caliper, measure the inner diameter [b] of the rear housing bush.


c.

Calculate the oil clearance.

Oil clearance = Inner diameter of the bush [b] - Outer diameter of the shaft [a]

Maximum oil clearance:

0.08 mm (0.00315 in.)


If the oil clearance is more than the maximum, replace the vane pump assembly.


Hide 2.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATES

a.
C114411E03
2.271,0.07 2.488,0.247 0.217,0.177 10 *a

Using a micrometer, measure the thickness of the 10 vane pump plates.

Text in Illustration
*a Thickness

Standard thickness:

1.405 to 1.411 mm (0.0553 to 0.0556 in.)


If the thickness is not as specified, replace the vane pump assembly.


b.
C114412

Using a feeler gauge, measure the clearance between the side face of the rotor groove and the plate.

Maximum clearance:

0.03 mm (0.00118 in.)


If the clearance is more than the maximum, replace the vane pump assembly.


Hide 3.INSPECT FLOW CONTROL VALVE (w/o Variable Flow Control Solenoid Valve)

a.
C161395

Coat the flow control valve with power steering fluid and check that it falls smoothly into the valve hole by its own weight.

If the control valve does not fall into the hole smoothly, replace the vane pump assembly.


b.
C114414

Check the flow control valve for leakage.

i.

Close one of the holes and apply 390 to 490 kPa (4.0 to 4.9 kgf/cm2, 57 to 71 psi) of compressed air into the opposite side hole, and confirm that air does not come out from the end holes.

If air leaks, replace the vane pump assembly.



Hide 4.INSPECT FLOW CONTROL VALVE COMPRESSION SPRING (w/o Variable Flow Control Solenoid Valve)

a.
C114415

Using a vernier caliper, measure the free length of the compression spring.

Minimum free length:

31.3 mm (1.23 in.)


If the length is less than the minimum, replace the vane pump assembly.


Hide 5.INSPECT PRESSURE PORT UNION (w/o Variable Flow Control Solenoid Valve)

a.

Visually check the pressure port union for fluid leaks.

If there is a leak, replace the vane pump assembly.