The power steering ECU receives signals from the ECM, steering sensor, skid control ECU and steering control ECU via the CAN communication system.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | The engine speed signal is lost. | ·
ECM ·
CAN communication system ·
Power steering ECU assembly |
| U0126 | The steering angle signal is lost. | ·
Steering sensor ·
CAN communication system ·
Power steering ECU assembly |
| U0129 | The vehicle speed signal is lost. | ·
Skid control ECU ·
CAN communication system ·
Power steering ECU assembly |
| U0130 | The VGRS relative angle signal is lost. | ·
Steering control ECU ·
CAN communication system ·
Power steering ECU assembly |
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve)>DTC CHECK / CLEAR).
| Result | Proceed to | |
|---|---|---|
| DTC is not output. | A | |
| DTC is output. | for LHD | B |
| for RHD | C | |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C