Home › Steering › STEERING COLUMN › HEATED STEERING WHEEL SYSTEM
RM2660E _55 Steering _052826 STEERING COLUMN _0255459 HEATED STEERING WHEEL SYSTEM D

STEERING COLUMN  HEATED STEERING WHEEL SYSTEM  SYSTEM DESCRIPTION  


HEATED STEERING WHEEL SYSTEM


a.

The heated steering wheel heats the steering wheel when the steering heater switch is operated.


b.

The heated steering wheel uses a thermistor inside of the steering wheel to detect the heater temperature and maintain the set temperature.


c.

The heated steering wheel timer function turns off the heater after a predetermined period of time.



HEATER CONTROLLER SYSTEM


a.

Operation description

C147022E05
0.573,0.472 1.283,0.638 0.710,0.166 10 OFF mode 0.707,0.744 1.503,0.909 0.795,0.166 10 - Heater off 0.707,1.021 1.354,1.187 0.647,0.166 10 - LED off 4.304,0.385 5.806,0.550 1.502,0.166 10 Normal warming mode 2.294,0.603 3.942,0.768 1.648,0.166 10 Press momentary switch 2.294,1.208 3.928,1.374 1.634,0.166 10 Press momentary switch 2.294,1.466 3.146,1.631 0.852,0.166 10 After 30 min. 3.253,1.866 4.741,2.031 1.489,0.166 10 Thermistor malfunction 2.825,2.144 4.884,2.501 2.059,0.357 10 Press momentary switch continuously for 10 sec. or more 5.353,1.839 7.146,2.005 1.793,0.166 10 Thermistor returns to normal 5.353,2.11 6.620,2.467 1.267,0.357 10 Momentary switch returns to normal 1.882,3.363 3.537,3.529 1.655,0.166 10 Press momentary switch 1.882,3.621 2.734,3.787 0.852,0.166 10 After 30 min. 4.438,0.656 5.601,0.822 1.163,0.166 10 - Heater on or off 4.526,0.921 6.332,1.087 1.807,0.166 10 (depending on temperature) 4.438,1.2 5.630,1.366 1.191,0.166 10 - LED illuminated 4.254,2.917 5.926,3.083 1.672,0.166 10 Malfunction display mode 4.389,3.189 5.184,3.355 0.795,0.166 10 - Heater off 4.389,3.471 5.580,3.636 1.191,0.166 10 - LED blinking

i.

When the ignition switch is ON, pressing the steering wheel controller momentary switch on the steering heater switch illuminates the LED and current is output from the steering controller to the heater of the heated steering wheel. Pressing the momentary switch again turns off the LED and stops the current from being output.


ii.

A thermostat is installed in the steering wheel as a safety mechanism.


iii.

The heated steering wheel switch LED will blink at 0.3 second intervals when either of the following occurs: 1) an open or short in the steering wheel thermistor continues for 2 seconds or more; or 2) the steering heater switch momentary switch is pressed continuously for 10 seconds or more.


iv.

If the normal condition is restored for 2 seconds or more, the previous operation before the malfunction occurred continues. However, regardless of if a malfunction is detected and the malfunction operation is occurring, and regardless of if the normal condition is restored and the system is operating normally, the timer will turn off the heater 30 minutes after the switch was first turned on.



b.

Signal input / output description

C147023E03
0.373,0.49 0.814,0.666 0.442,0.176 10 Power 0.347,1.164 1.826,1.339 1.480,0.176 10 Operation Switch Input 0.29,2.67 1.946,2.846 1.656,0.176 10 Temperature Setting Input 0.398,1.922 1.448,2.098 1.050,0.176 10 Thermistor Input 1.917,0.498 2.770,0.673 0.853,0.176 10 Latch Circuit 4.684,0.72 5.465,0.896 0.781,0.176 10 LED Output 4.606,1.391 5.529,1.548 0.923,0.157 10 Heater Output 6.29,1.391 6.625,1.548 0.335,0.157 10 FET 6.202,2.306 6.696,2.463 0.494,0.157 10 Heater 3.233,3.13 4.203,3.306 0.970,0.176 10 Microcomputer

Signal Signal Name Function Signal Type
Input Thermistor input Input of voltage corresponding to heater temperature Analog input
Input Temperature setting input Input of voltage corresponding to temperature setting Analog input
Input Operating switch input Input of power circuit latch operation estimate signal LOW / HI input
Output LED output Output of LED LOW / HI input
Output Heater output Output of heater LOW / HI input
Output Latch output Power circuit maintenance LOW / HI input


c.

Safety function

Content Operation
When thermistor trouble is detected Heater off
When overheating (175°C (347°F)) of controller is detected Heater off
When load short current (50 A or more) is detected Heater off
When undervoltage (4.5 V) is detected Heater off
OFF timer (30 min.) After preset time of timer passes, heater off
Reverse voltage protection Protection circuit operates