Home › Steering › STEERING COLUMN › TILT AND TELESCOPIC MANUAL SWITCH › from 2015.08
RM2660E _55 Steering _052826 STEERING COLUMN _0255462 TILT AND TELESCOPIC MANUAL SWITCH A

STEERING COLUMN  TILT AND TELESCOPIC MANUAL SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.

Disable the AUTO TILT AWAY function by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.



b.

Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.


c.

Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).



Hide 45287 3.REMOVE LOWER STEERING COLUMN COVER

a.
C335456

Remove the 2 screws.

HINT:

Turn the steering wheel to the right and left as necessary to remove the 2 screws.



b.
U156471E03
0.5,2.823 1.333,3.083 0.833,0.26 10 true Push Area 2.24,2.802 3.073,3.063 0.833,0.26 10 false Push Area

Remove the screw and while pressing the push area shown in the illustration to detach the 2 claws, slightly lower steering column cover.


Hide 89235A 4.REMOVE TILT AND TELESCOPIC MANUAL SWITCH

a.
C335503

Disconnect the connector.


b.

Detach the claw and pull out the switch.