Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
86160Z
1.INSTALL REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)
Align the speaker to the door position pins labeled A.
Install the speaker with the 2 screws.
Do not touch the cone part of the speaker.
Attach the clamp and connect the connector.
86160C
2.INSTALL REAR SPEAKER SET
Temporarily install the speaker by attaching the claw of the speaker to the door panel.
Install the speaker with the 3 screws.
Do not touch the cone part of the speaker.
Connect the connector.
67604
3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74646
4.INSTALL DOOR ASSIST GRIP COVER LH
74280
5.INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH
Connect the connector.
Attach the 7 claws to install the armrest base panel.
69278C
6.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).