Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255476 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Sound Signal Circuit between Multi-display Controller and Head-phone Terminal  


DESCRIPTION

This is the sound signal circuit between the multi-display controller sub-assembly and headphone terminal.

WIRING DIAGRAM

E248577E13
1.486,0.859 1.952,1.010 0.466,0.151 10 HP2R 1.486,1.186 2.023,1.337 0.537,0.151 10 HP2L 1.486,1.493 1.906,1.644 0.420,0.151 10 SLD6 1.486,2.68 1.952,2.832 0.466,0.151 10 HR1R 1.486,3.007 2.023,3.159 0.537,0.151 10 HP1L 1.486,3.314 1.906,3.466 0.420,0.151 10 SLD5 5.283,2.694 5.748,2.846 0.466,0.151 10 HP1R 5.283,3.021 5.820,3.173 0.537,0.151 10 HP1L 5.283,3.328 5.703,3.480 0.420,0.151 10 SGN1 2.004,0.755 2.211,0.916 0.207,0.161 10 7 2.004,1.073 2.211,1.233 0.207,0.161 10 9 2.004,1.39 2.211,1.551 0.207,0.161 10 8 2.004,2.591 2.211,2.751 0.207,0.161 10 3 2.004,2.908 2.211,3.069 0.207,0.161 10 5 2.004,3.226 2.211,3.386 0.207,0.161 10 4 5.086,2.591 5.293,2.751 0.207,0.161 10 9 5.015,2.908 5.222,3.069 0.207,0.161 10 10 5.031,3.226 5.237,3.386 0.207,0.161 10 11 5.283,0.859 5.748,1.010 0.466,0.151 10 HP2R 5.283,1.186 5.820,1.337 0.537,0.151 10 HP2L 5.283,1.493 5.703,1.644 0.420,0.151 10 SGN2 1.01,3.959 2.483,4.342 1.473,0.383 10 Multi-display Controller Sub-assembly 4.909,3.959 6.416,4.179 1.507,0.220 10 Headphone Terminal 1.01,3.772 1.383,3.960 0.373,0.188 10 L66 4.914,3.772 5.287,3.960 0.373,0.188 10 P1 5.096,0.745 5.302,0.906 0.207,0.161 10 1 5.096,1.063 5.302,1.223 0.207,0.161 10 2 5.096,1.381 5.302,1.541 0.207,0.161 10 3 2.584,1.629 3.198,1.799 0.614,0.170 10 * 3.578,1.629 4.192,1.799 0.614,0.170 10 * 4.553,1.629 5.167,1.799 0.614,0.170 10 * 3.266,4.402 4.275,4.572 1.010,0.170 10 *: Shielded 3.578,3.506 4.192,3.676 0.614,0.170 10 * 4.553,3.506 5.167,3.676 0.614,0.170 10 * 2.584,3.506 3.198,3.676 0.614,0.170 10 *

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - HEADPHONE TERMINAL)
a.

Disconnect the L66 multi-display controller sub-assembly connector.


b.

Disconnect the P1 headphone terminal connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L66-7 (HP2R) - P1-1 (HP2R) Always Below 1 Ω
L66-9 (HP2L) - P1-2 (HP2L) Always Below 1 Ω
L66-8 (SLD6) - P1-3 (SGN2) Always Below 1 Ω
L66-3 (HR1R) - P1-9 (HP1R) Always Below 1 Ω
L66-5 (HP1L) - P1-10 (HP1L) Always Below 1 Ω
L66-4 (SLD5) - P1-11 (SGN1) Always Below 1 Ω
L66-7 (HP2R) - Body ground Always 10 kΩ or higher
L66-9 (HP2L) - Body ground Always 10 kΩ or higher
L66-8 (SLD6) - Body ground Always 10 kΩ or higher
L66-3 (HR1R) - Body ground Always 10 kΩ or higher
L66-5 (HP1L) - Body ground Always 10 kΩ or higher
L66-4 (SLD5) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR