Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255476 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Display Signal Circuit between Radio Receiver and Television Display Assembly  


DESCRIPTION

This is the display signal circuit from the multi-media module receiver assembly to the television display assembly.

WIRING DIAGRAM

E248576E03
5.323,0.844 5.792,0.99 0.469,0.146 10 false NTSO 5.323,1.573 5.865,1.719 0.542,0.146 10 false NTSG 5.323,2.313 5.74,2.458 0.417,0.146 10 false SLD2 5.052,0.74 5.26,0.896 0.208,0.156 10 false 1 5.063,1.469 5.271,1.625 0.208,0.156 10 false 2 5.063,2.208 5.271,2.365 0.208,0.156 10 false 3 1.5,0.844 1.969,0.99 0.469,0.146 10 false NTS4 1.51,1.594 2.052,1.74 0.542,0.146 10 false SGN4 1.51,2.323 1.927,2.469 0.417,0.146 10 false SLD4 1.021,2.979 2.281,3.365 1.26,0.385 10 false Television Display Assembly 5.031,2.958 6.417,3.354 1.385,0.396 10 false Multi-media Module Receiver Assembly 1.021,2.813 1.396,3 0.375,0.188 10 false L53 5.031,2.76 5.406,2.948 0.375,0.188 10 false F78 2.01,0.74 2.219,0.896 0.208,0.156 10 false 20 2.01,1.51 2.219,1.667 0.208,0.156 10 false 19 2.01,2.219 2.219,2.375 0.208,0.156 10 false 18 2.667,2.5 3.281,2.667 0.615,0.167 10 false Shielded 3.948,2.5 4.563,2.667 0.615,0.167 10 false Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
a.

Disconnect the F78 multi-media module receiver assembly connector.


b.

Disconnect the L53 television display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F78-1 (NTSO) - L53-20 (NTS4) Always Below 1 Ω
F78-2 (NTSG) - L53-19 (SGN4) Always Below 1 Ω
F78-3 (SLD2) - L53-18 (SLD4) Always Below 1 Ω
F78-1 (NTSO) - Body ground Always 10 kΩ or higher
F78-2 (NTSG) - Body ground Always 10 kΩ or higher
F78-3 (SLD2) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR