This circuit provides power to the radio receiver.
Inspect the fuse for circuits related to this system before performing the following inspection procedure.
Disconnect the F35 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F35-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F35-4 (B) - Body ground | Always | 11 to 14 V |
| F35-3 (ACC) - Body ground | Ignition switch ACC |
| *1 | Front view of wire harness connector
(to Radio Receiver) |
OK
NG