Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/ Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255478 AUDIO AND VISUAL SYSTEM(w/ Navigation System) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Navigation System)  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the multi-media module receiver assembly through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly or multi-media module receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, multi-media module receiver assembly or speakers.

WIRING DIAGRAM

C253556E04
0.352,3.506 1.586,3.900 1.234,0.394 10 No. 1 Stereo Jack Adapter Assembly 0.352,3.348 0.826,3.522 0.475,0.174 10 z62 5.592,3.506 6.918,3.831 1.326,0.325 10 Multi-media Module Receiver Assembly 5.592,3.348 6.002,3.522 0.410,0.174 10 F78 5.844,0.909 6.283,1.083 0.439,0.174 10 ADPG 0.94,2.802 1.402,2.977 0.462,0.174 10 AGND 1.474,2.712 1.688,2.887 0.214,0.174 10 9 0.94,2.34 1.396,2.514 0.456,0.174 10 ASGN 1.474,2.25 1.688,2.424 0.214,0.174 10 7 0.94,0.911 1.431,1.085 0.491,0.174 10 AUXO 1.474,0.821 1.688,0.995 0.214,0.174 10 8 5.844,1.387 6.335,1.562 0.491,0.174 10 VAR+ 1.038,1.387 1.529,1.562 0.491,0.174 10 ARO 1.474,1.297 1.688,1.472 0.214,0.174 10 5 1.038,1.878 1.463,2.052 0.425,0.174 10 ALO 1.474,1.788 1.688,1.962 0.214,0.174 10 6 5.844,2.802 6.310,2.977 0.466,0.174 10 AGND 5.619,2.712 5.833,2.887 0.214,0.174 10 5 5.844,2.34 6.294,2.514 0.450,0.174 10 VA- 5.563,2.25 5.777,2.424 0.214,0.174 10 15 5.844,1.878 6.269,2.052 0.425,0.174 10 VAL+ 5.619,1.297 5.827,1.472 0.208,0.174 10 7 5.563,0.821 5.771,0.995 0.208,0.174 10 16 5.619,1.788 5.833,1.962 0.214,0.174 10 8 2.672,2.995 3.282,3.174 0.610,0.179 10 Shielded 3.947,2.995 4.557,3.174 0.610,0.179 10 Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F78 multi-media module receiver assembly connector.


b.

Disconnect the z62 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F78-16 (ADPG) - z62-8 (AUXO) Always Below 1 Ω
F78-7 (VAR+) - z62-5 (ARO) Always Below 1 Ω
F78-8 (VAL+) - z62-6 (ALO) Always Below 1 Ω
F78-15 (VA-) - z62-7 (ASGN) Always Below 1 Ω
F78-5 (AGND) - z62-9 (AGND) Always Below 1 Ω
F78-16 (ADPG) - Body ground Always 10 kΩ or higher
F78-7 (VAR+) - Body ground Always 10 kΩ or higher
F78-8 (VAL+) - Body ground Always 10 kΩ or higher
F78-15 (VA-) - Body ground Always 10 kΩ or higher
F78-5 (AGND) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR