Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/o Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255479 AUDIO AND VISUAL SYSTEM(w/o Navigation System) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/o Navigation System)  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E141050E35
1.125,0.781 2.042,0.99 0.917,0.208 10 false from Battery 0.906,1.979 2.083,2.188 1.177,0.208 10 false from ACC Relay 3.583,1.052 4.323,1.26 0.74,0.208 10 false RAD NO. 1 3.75,2.25 4.073,2.458 0.323,0.208 10 false ACC 6.125,0.76 6.354,0.969 0.229,0.208 10 false B 6.125,1.969 6.542,2.177 0.417,0.208 10 false ACC 6.135,3.177 6.552,3.385 0.417,0.208 10 false GND 5.865,0.646 6.094,0.854 0.229,0.208 10 false 1 5.802,1.823 6.031,2.031 0.229,0.208 10 false 11 5.792,3.042 6.021,3.25 0.229,0.208 10 false 20 5.323,4.958 6.979,5.292 1.656,0.333 10 false Radio Receiver Assembly 5.344,4.75 5.656,4.958 0.313,0.208 10 false F1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY
a.
U165829E02
1.01,1.479 0.646,1.479 false 1,1.719 0.635,1.719 false 2.802,1.708 2.427,1.708 false 0.125,0.125 0.406,0.448 0.281,0.323 10 false *1 2.833,1.635 3.229,1.854 0.396,0.219 10 false GND 0.5,1.406 0.698,1.625 0.198,0.219 10 false B 0.292,1.656 0.781,1.875 0.49,0.219 10 false ACC 0.5,0.938 0.781,1.156 0.281,0.219 10 false F1

Disconnect the F1 radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F1-20 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F1-1 (B) - F1-20 (GND) Always 11 to 14 V
F1-11 (ACC) - F1-20 (GND) Engine switch on (ACC) 11 to 14 V


Text in Illustration
*1 Front view of wire harness connector
(to Radio Receiver Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR