This circuit provides power to the stereo component amplifier assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the F2 and F18 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F2-2 (GND) - Body ground | Always | Below 1 Ω |
| F2-6 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F2-3 (+B2) - F2-2 (GND) | Always | 11 to 14 V |
| F18-12 (ACC) - F2-2 (GND) | Engine switch on (ACC) | 11 to 14 V |
| *1 | Front view of wire harness connector
(to Stereo Component Amplifier Assembly) |
| *2 | Front view of wire harness connector
(to Stereo Component Amplifier Assembly) |
OK
NG