1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64910J
3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
4.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)
Use the same procedures described for the LH side (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).
5.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)
Use the same procedures described for the LH side (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL).
58574A
6.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
51775
7.REMOVE REAR STEP COVER
67917C
8.REMOVE REAR DOOR SCUFF PLATE RH
71845B
9.REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)
64937A
10.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)
62510P
11.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
86150
12.REMOVE NO. 1 WOOFER BOX SPEAKER ASSEMBLY
Disconnect the connector.
Remove the 5 bolts and box speaker.