1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67939B
3.REMOVE CENTER BACK DOOR GARNISH
67938A
4.REMOVE BACK DOOR SIDE GARNISH LH
67937B
5.REMOVE BACK DOOR SIDE GARNISH RH
74611B
6.REMOVE ASSIST GRIP (for Face to Face Seat Type)
67848C
7.REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type)
84965
8.REMOVE DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type)
64780A
9.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
86160T
10.REMOVE REAR HEADER SPEAKER ASSEMBLY
Use the same procedure as for the opposite side.
Remove the 3 screws.
Disconnect the connector and remove the rear header speaker assembly.