Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255487 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E250925E17
5.046,2.036 6.322,2.402 1.276,0.366 10 Radio and Display Receiver Assembly 5.046,1.882 5.527,2.033 0.481,0.151 10 F120 2.658,1.377 2.959,1.543 0.301,0.166 10 E53 2.658,1.545 3.863,1.926 1.205,0.381 10 Parking Brake Switch Assembly 5.405,1.058 5.759,1.239 0.354,0.181 10 PKB 5.167,0.974 5.359,1.143 0.192,0.168 10 15 3.682,0.974 3.818,1.143 0.137,0.168 10 1

CAUTION / NOTICE / HINT

HINT:

When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
U116554E01
0.128,1.122 0.311,1.193 0.183,0.071 0.128,1.122 0.311,1.193 0.183,0.071

Display the "Vehicle Signal Check Mode" screen (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>OPERATION CHECK).


b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Position Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.




OK

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the E53 parking brake switch assembly connector.


b.

Disconnect the F120 radio and display receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F120-15 (PKB) - E53-1 Always Below 1 Ω
F120-15 (PKB) - Body ground Always 10 kΩ or higher




OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE LEVER>REMOVAL).


b.
C217121

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
Switch connector terminal - Switch body On (Shaft not pressed) Below 1 Ω
Off (Shaft pressed) 10 kΩ or higher


Text in Illustration
V100135

On
V100136

Off



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY