The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1579 | Telephone microphone signal is lost. | ·
Radio and display receiver assembly ·
Roof console box assembly ·
Telephone microphone assembly ·
Harness or connector |
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F124-18 (SGND) - Body ground | Always | Below 1 Ω |
| F124-19 (MIN-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F124-4 (MACC) - Body ground | Engine switch on (ACC) | 4 to 6 V |
| *a | Component with harness connected
(Radio and Display Receiver Assembly) |
OK
NG
Disconnect the F124 radio and display receiver assembly connector.
Disconnect the R7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F124-4 (MACC) - R7-25 (ACC) | Always | Below 1 Ω |
| F124-5 (MIN+) - R7-27 (MI1+) | Always | Below 1 Ω |
| F124-19 (MIN-) - R7-26 (MIC-) | Always | Below 1 Ω |
| F124-6 (SNS2) - R7-20 (SNS2) | Always | Below 1 Ω |
| F124-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| F124-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| F124-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| F124-18 (SGND) - Body ground | Always | 10 kΩ or higher |
| F124-6 (SNS2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the telephone microphone assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).
Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG