These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | CAN bus connection error | CAN communication system |
| U0100 | CAN reception error | |
| U0129 | CAN reception error | |
| U0140 | CAN reception error | |
| U0155 | CAN reception error | |
| U0164 | CAN reception error | |
| U1110 | CAN reception error |
Use the GTS to check if the CAN communication system is functioning normally.
for LHD with Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with Central Gateway ECU)>DIAGNOSIS SYSTEM
for LHD without Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD without Central Gateway ECU)>DIAGNOSIS SYSTEM
for RHD with Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with Central Gateway ECU)>DIAGNOSIS SYSTEM
for RHD without Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD without Central Gateway ECU)>DIAGNOSIS SYSTEM
CAN communication DTCs are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD with Central Gateway ECU) | B |
| NG (for LHD without Central Gateway ECU) | C |
| NG (for RHD with Central Gateway ECU) | D |
| NG (for RHD without Central Gateway ECU) | E |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E