Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255487 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E280107E14
5.677,1.146 6.292,1.344 0.615,0.198 10 false US1+ 5.677,0.656 6.292,0.854 0.615,0.198 10 false US1- 5.396,1.042 5.563,1.24 0.167,0.198 10 false 3 5.396,0.552 5.573,0.74 0.177,0.188 10 false 2 1.677,1.042 2.292,1.24 0.615,0.198 10 false 3 1.656,0.51 2.271,0.708 0.615,0.198 10 false 2 1.219,0.667 1.833,0.865 0.615,0.198 10 false US1- 1.198,1.188 1.813,1.385 0.615,0.198 10 false US1+ 0.479,1.552 0.74,1.74 0.26,0.188 10 false B 0.469,1.781 1.708,2.229 1.24,0.448 10 false No. 1 Stereo Jack Adapter Assembly 5.448,1.531 6.063,1.729 0.615,0.198 10 false A 5.438,1.729 6.74,2.188 1.302,0.458 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the A radio and display receiver assembly connector.


b.

Disconnect the B No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 (US1-) - B-2 (US1-) Always Below 1 Ω
A-3 (US1+) - B-3 (US1+) Always Below 1 Ω
A-2 (US1-) - Body ground Always 10 kΩ or higher
A-3 (US1+) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR