Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255487 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display data signal of an external device to the radio and display receiver assembly through this circuit.

WIRING DIAGRAM

E335093E03
5.677,2.365 6.083,2.573 0.406,0.208 10 false F124 5.99,0.74 6.521,0.948 0.531,0.208 10 false VV+ 5.698,0.698 5.885,0.906 0.188,0.208 10 false 13 5.99,1.375 6.521,1.583 0.531,0.208 10 false VV- 5.698,1.302 5.885,1.51 0.188,0.208 10 false 14 5.969,1.958 6.5,2.167 0.531,0.208 10 false SG 5.698,1.885 5.885,2.094 0.188,0.208 10 false 12 0.927,0.771 1.229,0.979 0.302,0.208 10 false VV+ 0.979,1.417 1.24,1.625 0.26,0.208 10 false VV- 1.323,0.688 1.51,0.896 0.188,0.208 10 false 5 1.323,1.302 1.51,1.51 0.188,0.208 10 false 10 5.677,2.542 6.99,2.958 1.313,0.417 10 false Radio and Display Receiver Assembly 0.292,2.479 1.604,2.896 1.313,0.417 10 false No. 1 Stereo Jack Adapter Assembly 4.135,2.135 4.854,2.323 0.719,0.188 10 false Shielded 2.292,2.146 3.01,2.333 0.719,0.188 10 false Shielded 0.292,2.292 0.698,2.5 0.406,0.208 10 false t1

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F124 radio and display receiver assembly connector.


b.

Disconnect the t1 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F124-13 (VV+) - t1-5 (VV+) Always Below 1 Ω
F124-14 (VV-) - t1-10 (VV-) Always Below 1 Ω
F124-13 (VV+) - Body ground Always 10 kΩ or higher
F124-14 (VV-) - Body ground Always 10 kΩ or higher
F124-12 (SG) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR